A tutorial on how to setup a mail server to route and relay mail through Verizon’s SMTP servers. BY TECHGONEWILD.
Video Rating: 5 / 5
Feb
21
Feb
21
A tutorial on how to setup a mail server to route and relay mail through Verizon’s SMTP servers. BY TECHGONEWILD.
Video Rating: 5 / 5
5 comments
No ping yet
Nermin Sahmanovic says:
February 21, 2014 at 6:24 pm (UTC 0)
Thank you very much for such a helpful video. it helped me configure my
send connector after many days of many unsuccessful attempts. Now i can
send emails out of my Exchange server 2013. However I am not able to
receive any external emails back to my Exchange 2013 Server.
Thanks again
Ali Akbar says:
February 21, 2014 at 7:23 pm (UTC 0)
What roles are needed to install on exchange server 2007 for smart host
configuration.
i can see you have installed client access, hub transport.
Joe Rodriguez says:
February 21, 2014 at 7:23 pm (UTC 0)
Are these settings still working for you? I’m able to receive to my
exchange server but still cannot send even after I followed your
instructions.
Todd Montague says:
February 21, 2014 at 8:06 pm (UTC 0)
Do you have an update for the new servers Verizon is turning on? I received
an email that they are migrating to smtp.verizon.net at port 465. My
smarthost was working as you indicated but when I try to change it to the
new smtp.verizon.net and set the port to 465, it’s failing. I’m getting no
emails routing.
susandi98 says:
February 21, 2014 at 8:47 pm (UTC 0)
I could not get this to work. I had done all of this already, and upon
seeing this video did it again, including running the shell command, which
was already set. Any suggestions would be greatly appreciated. Nothing
sends outside my intranet.